Brocade FastIron Ethernet Switch Platform and Layer 2 Switching Configuration Guide - Manual (Page 440)

failover
Enables or disables LAG hardware failover.
Enables LAG hardware failover. The no form of this command disables LAG hardware failover.
Syntax failover {next | all}
no failover {next | all}
Command Default LAG hardware failover is not enabled by default.
Modes Dynamic LAG configuration mode
Usage Guidelines Use this command to enable or disable LAG hardware failover. Use the all parameter to enable failover
on all ports in LAG. Use the next parameter to enable failover on the next port in LAG.
Examples The following example enables LAG failover next:
device(config)# lag one dynamic
device(config-lag-one)# failover next
The following example enables LAG failover all:
device(config)# lag one dynamic
device(config-lag-one)# failover all
History
Release version Command history
08.0.10 This command was introduced.
failover
440 FastIron Ethernet Switch Platform and Layer 2 Switching Configuration Guide
53-1003086-04