Brocade Multi-Service IronWare YANG Configuration Guide (Supporting R05.6.00) - Manual (Page 45)

Multi-Service IronWare YANG Configuration Guide 37
53-1003038-02
Full examples
3
}
}
}
The following example shows the RPC request and response of an <edit-config> operation.
<nc:rpc message-id="1" xmlns:nc="urn:ietf:params:xml:ns:netconf:base:1.0"
xmlns:brcd="http://brocade.com/ns/netconf/config/netiron-config/">
<nc:edit-config>
<nc:target>
<nc:running/>
</nc:target>
<nc:config>
<brcd:netiron-config>
<brcd:vlan-config>
<brcd:vlan>
<brcd:vlan-id>2</brcd:vlan-id>
<brcd:untagged>ethernet 1/6 to 1/8</brcd:untagged>
<brcd:router-interface> ve 2</brcd:router-interface>
</brcd:vlan>
</brcd:vlan-config>
<brcd:interface-config>
<brcd:interface>
<brcd:interface-id>ethernet 1/1</brcd:interface-id>
<brcd:enable></brcd:enable>
<brcd:ip>
<brcd:address>1.1.1.1/24</brcd:address>
</brcd:ip>
<brcd:ipv6>
<brcd:address>2000:0:0:1::1/64</brcd:address>
<brcd:enable></brcd:enable>
</brcd:ipv6>
<brcd:flow-control></brcd:flow-control>
<brcd:load-interval>30</brcd:load-interval>
<brcd:drop-precedence>
<brcd:value>0</brcd:value>
</brcd:drop-precedence>
<brcd:route-only></brcd:route-only>
</brcd:interface>
<brcd:interface>
<brcd:interface-id>ethernet 1/2</brcd:interface-id>
<brcd:enable></brcd:enable>
<brcd:ip>
<brcd:address>1.1.12.1/24</brcd:address>
</brcd:ip>
<brcd:ipv6>
<brcd:address>2000:0:0:12::1/64</brcd:address>
<brcd:enable></brcd:enable>
</brcd:ipv6>
<brcd:flow-control></brcd:flow-control>
<brcd:load-interval>30</brcd:load-interval>
<brcd:drop-precedence>
<brcd:value>0</brcd:value>
</brcd:drop-precedence>
<brcd:route-only></brcd:route-only>
</brcd:interface>
<brcd:interface>