Brocade Unified IP MIB Reference (Supporting FastIron Releases 07.5.00 and 08.0.10) - Manual (Page 167)

Unified IP MIB Reference 141
53-1003106-01
Default gateway IP address
5
Default gateway IP address
The following table lists the MIB object for the default gateway IP address.
Configuration notes
When using the snAgGblPassword object in a Set operation, the following must be considered:
The device always insist on a password to be part of snAgGblPassword object. You can override this
requirement by entering the no snmp-server pw-check command.
By default, the object uses the value of the enable super-user password configured on the device
as the default password. To allow a device to use other authentication schemes, use the aaa
authen snmp-server default enable | local | none command.
The enable option instructs the device to use the configured enable super-user password. If the
enable super-user password is missing, then the device checks for the if implicit TACACS+ enable
password. The device stores a previous (unrelated to SNMP) implicit enable operation result and
remembers the enable password that was approved by TACACS+. You can enter the following
command to use this method.
SnmpSet(snAgGblPassword.0="<enable-password>", snAgEraseNVRAM.0=3)
The local option instructs the device to use a configured local username and password value. You
can enter the following SNMP command to use this method.
SnmpSet(snAgGblPassword.0="<username> <password>", snAgEraseNVRAM.0=3)
snAgTftpServerAddr
brcdIp.1.1.2.1.66
Syntax: DisplayString Read-write Shows the TFTP server IP address.
snAgGblPasswordCheck
Mode
brcdIp.1.1.2.1.68
Syntax: EnabledStatus
NOTE: This object is
supported only
on the Brocade
FastIron SX,
Brocade FCX,
Brocade ICX
6610, Brocade
ICX 6430, and
Brocade ICX
6450 devices.
Read-only When enabled all image- or file-related MIB object SET request PDUs
must include the password using the snAgGblPassword object.
•
enabled(1) - The password checking for SNMP SET request is
enabled. The default value is enabled(1).
•
disabled(2) - The password checking for SNMP SET request is
disabled.
Name, OID, and syntax Access Description
Name, OID, and syntax Access Description
snAgDefGwayIp
brcdIp.1.1.2.1.10
Syntax: Integer Read-write Shows the IP address of the default gateway router.