Managing software images, Uploading the software, Chapter 16 – Brocade Virtual ADX Graphical User Interface Guide (Supporting ADX v03.1.00) User Manual
Page 251
Brocade Virtual ADX Graphical User Interface Guide
239
53-1003242-01
Chapter
16
Managing Software Images
In this chapter
•
Uploading the software
You can upload a software image on the device from a Trivial File Transfer Protocol (TFTP) server.
While uploading the image, make sure that there are no power failures.
To upload the software image from the TFTP server, perform the following steps within the Maintain
tab.
1. Click System on the menu bar.
2. From the sidebar, select Software Upload.
The Software Upload page is displayed, as shown in
FIGURE 167
Uploading the software
3. Provide the following information:
•
TFTP Server: Enter the IP address of the TFTP server.
•
Software Image: Enter the name of the software image.
•
Image: Click Primary or Secondary image in which you want to upload the software image.
By default, the primary flash image is selected.
•
Save Configuration before reboot: Select the check box to save the running configuration
before reboot.