RIKON Power Tools 50-142 - Manual (Page 10)

10
Fig.22
Fig.23
Mounting Sander
Once you have confirmed that your machine is
running properly, mount it to a workbench. The
strongest mounting option is a "Through Mount"
where holes are drilled all the way through the
workbench, and hex bolts, washers, and lock
nuts are used to secure the sander to the work-
bench. Another option for mounting is a “Direct
Mount” where the machine is simply secured to
the workbench with a lag screw.
Note: To reduce vibration when operating, keep
the rubber cushion included with your sander
between the machine base and the workbench.
Dust Collection
To connect a dust collection hose:
1. Install a 2” dust hose from a dust collection
system over each dust port, and secure them in
place with a 2” hose clamp.
2. Tug the hoses to make sure they do not
come off.
CAUTION
DO NOT operate this sander without
an adequate dust collection system. This
sander creates substantial amounts of wood
dust while operating. Failure to use a dust col-
lection system can result in short and long-term
respiratory illness.
Assembly
California Proposition 65 Warning
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains
chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.Your risk from
exposure to these chemicals varies, depending on how often you do this type of work. To reduce your exposure, work in
a well-ventilated area and with approved safety equipment, such as dust masks that are specially designed to filter out
microscopic particles.
For more detailed information about California Propostion 65 log onto rikontools.com.