ShelterLogic 27273 24 x 40 UltraMax Peak Canopy - Manual (Page 4)

STEP 7
STEP 6
Depending on the model you have purchased, your
base feet will either fit onto the outside of the leg poles,
or slide inside the leg poles. After installing Base Feet
Plates onto bottom of Support leg Poles, be sure to
line up the predrilled hole in the leg with the predrilled
hole in the base foot. Insert 5/16" x 3" bolts all the way
through leg and foot to other side, secure with nuts.
Note: Don't insert the bolt to the corner legs at this step.
Fig. 5A
Fig. 5B
Locate a suitable location to place 4 anchors as shown
in the illustration into each of the base feet until
the round end of the anchor touches the base feet.
STEP 5
Position the cover on the side of the frame with the side with the grommets parallel to the frame and facing down.
Go to the opposite side of the frame and throw at least three ropes over the frame (evenly spaced along the length
of the frame). Tie the ropes to the grommets on the cover and use the rope to pull the cover over the frame (the
more people and ropes you have to pull the cover over the easier it is to do). Position the cover so that the valance
is even front to back and side to side.
corner
clamps
11130
690
800220
Fig.7B
middle
clamps 11130
800221
690
Fig.7A
Fig.7
Pocket Pipe
Fig.6
Fig.6A
Fig.6B
Rope
PAGE 4
Slide the pocket pipes into the cover pockets between the cutouts. Attach the pocket pipes to the frame using the
3 & 4 way clamps (800220 & 800221) and the 5/16 X 2 #11130 bolts and nuts. Check that the pocket pipes are
evenly spaced on both sides of the top pipe. Slide the pocket pipe down the length of the rafters to tighten the top
section of the cover. When the cover is pulled tight secure the bolts and nuts in the sliding clamps to hold them in
place.
Tie a loop into the end of the
rope. Feed the loop over the
top of the rafter pole and feed
the other end of the rope through
the loop and run the rope down
the leg at least 12" and wrap
the rope around the leg and
feed the loose end over the
rope (Fig.6A).
Take the loose end of the robe
and secure it to the auger an-
chor already secured in the ground
(Fig.6B).Repeat these steps for the
remaining legs on the canopy.