Triton RT2000 User Manual - Manual (Page 132)

112
M
ODEL
RT2000 U
SER
M
ANUAL
Introduction
This chapter of the User manual covers
preventive and corrective maintenance
procedures appropriate for user person-
nel. The following areas are covered:
1. Replenishing Receipt Paper.
Describes how to replace a spent
receipt paper roll.
2. Cleaning the Enclosure. The
proper way to clean the ATM
housing.
3. Card Reader Cleaning. The
recommended card reader cleaning
technique.
4. Card Reader Problems. Servicing
card reader problems.
5. Communication Problems.
Servicing communications-related
problems.
*IMPORTANT*
Only qualified service personnel are
authorized to repair or service the
terminal. Should a malfunction oc-
cur, DO NOT attempt to service the
unit yourself! Contact your Triton
certified service provider!
1. Open the back of the cabinet sleeve
by unlocking the top enclosure and
pulling the hinged door open.
Replenishing the Receipt
Paper
NOTE: This operation must be com-
pleted with the AC Power applied to the
ATM.
2. If paper remains on the roll, cut the
paper between the roll and the
printer with a pair of scissors as
shown in Figure 6-1.
3. Press and hold the receipt printer
paper feed button (Figure 6-2) to
clear the printer of any receipt paper.
Figure 6-1. Cut paper between the
roll and input to the printer.
Figure 6-2. Paper feed button is
located on the paper bracket.
**WARNING**
Do not pull the paper backward
through the printer. This may leave
paper fragments that can cause pa-
per jams.