WEN 70711 10 inch Sliding Compound Miter Saw Manual - Manual (Page 14)

14
Your miter saw is wired at the factory for 120V operation . Connect to a 120V, 15 aMp time delay
fuse or circuit breaker . To avoid shock or fire, replace power cord immediately if it is worn, cut or
damaged in any way .
Use a separate electrical circuit for your tools.
This circuit must not be less than a #12 wire and should be protected with a 15 amp time delay
fuse . Before connecting the motor to the power line, make sure the switch is in the oFF position
and the electric current is rated the same as the current stamped on the motor nameplate . Running
at a lower voltage will damage the motor .
when operating a power tool outside, use an outdoor extension cord marked "w-a" or "w" . These
cords are rated for outdoor use and reduce the risk of electric shock .
This tool is intended for use on a circuit that has a receptacle like the
one illustrated: a 3-prong electrical plug (1) and receptacle (2) that has a
grounding conductor . if a properly grounded receptacle is not available, have
a certified electrician check the receptacle .
do not modify the power cord plug . if it does not match the electrical outlet, have the proper outlet
installed by a qualified electrician .
Double Insulated
The miter saw is double insulated to provide a double thickness of insulation between you and
the tool’s electrical system . all exposed metal parts are isolated from the internal metal motor
components with protecting insulation .
Replacement parts
when servicing use only identical replacement parts .
WARNING - This miter saw is for indoor use only . do not expose to rain or use
in damp location . This tool must be grounded while in use to protect the operator
from electrical shock .
This tool has an equipped grounding conductor and a grounding plug . The plug
must be used with a matching electrical outlet that is properly installed in accor-
dance with all local codes and ordinances .
WARNING - double insulation does not take the place of normal safety pre-
cautions when operating this tool . This tool is intended for indoor use only .