Detcon DM-700 - Manual (Page 18)

Model DM-700
DM-700 Instruction Manual Rev. 4.0 Page 14 of 48
3.2 Operator Interface
The operating interface is menu-driven via the two magnetic program switches located under the target marks
of the sensor housing. The two switches are referred to as “PGM1” and “PGM2”. The menu list consists of
three major items that include sub-menus as indicated below. (Refer to the complete Software Flow Chart
Figure 13.)
Normal Operation
Current Reading and Gas Type/Fault Status
Calibration Mode
AutoZero
AutoSpan
Program Mode
View Sensor Status
Sensor Model Type
Current Software Version
Gas Type
Range of Detection
Serial ID address
AutoSpan Level
Days Since Last AutoSpan
Remaining Sensor Life
mA Output
Input Voltage Supply
Sensor Temperature
Output
Bias Voltage
Gain Setting
Raw Counts
Set AutoSpan Level
Set Serial ID
Set Range
Signal Output Check
Restore Default Settings