Set modbus™ timeouts, Display settings – Detcon SmartWireless CXT User Manual

Page 44

Advertising
background image

Sentinel CXT

Sentinel CXT Instruction Manual

Rev. 1.5

Page 40 of 42

The Set COMM Baud Rates menu displays the current baud rate settings for COMM1 (master) and
COMM2 (slave).

Upon entering this menu, the LCD will display:

SET COMM BAUD RATES:

COMM1 BAUD RATE:9600
COMM2 BAUD RATE:9600

NOTE

The value shown is pre-configured to 9600 and should not be altered unless directed to do
so by Detcon factory personnel.

10.2.8 Set Modbus™ Timeouts

The Set Modbus™ Timeouts menu establishes the response timeout for Modbus™ communications and the
inter-poll delay. Response timeout is the amount of time in milliseconds the CXT controller will wait for a
sensor to respond to a poll request. Inter-poll delay is the amount of time in milliseconds the CXT will wait
after receiving a poll response from one sensor before it polls the next sensor. Ten missed poll responses
will result in the sensor being declared in COMM ERR. The range of values for the response timeout is
100-1000 milliseconds and 10-255 milliseconds for the inter-poll delay. The recommended value for the
response timeout is 500 and 150 for the inter-poll delay.

1. Upon entering this menu, the LCD will display:

SET MODBUS TIMEOUTS:

RESPONSE TIMEOUT:###

INTERPOLL DELAY:###

2. Values can be changed by swiping the magnet over the markers of the up or down arrows to move

the arrow prompt "

→" to the desired function. A swipe over:

 The ENTER marker will select the function indicated by the arrow prompt "→".

 The markers of the up or down arrows will change the value.

 The ENTER marker will save the selected value.

10.2.9 Display Settings

The Display Settings menu customizes the brightness, contrast and backlight duration of the display.
Values for brightness and contrast range between 0 and 100. Available values for the backlight timeout
function (turn off due to inactivity) are OFF, 10 seconds, 30 seconds and 1 to 5 minutes.

1. Upon entering this menu, the LCD will display:

DISPLAY SETTINGS

BRIGHTNESS: ###
BACKLIGHT TIMEOUT: #:##
CONTRAST: ###

Advertising