KROHNE OPTIMASS 8000K EN - Manual (Page 33)

TECHNICAL DATA
6
33
OPTIMASS 8000K
www.krohne.com 08/2010 - 4000921002 - MA OPTIMASS 8000k R02 en
Maximum end loadings
• These (axial) loads have been calculated, based on 316L schedule 40 process pipework,
where un-radiographed butt welds have been used in pipe joints.
• The loads shown are the maximum permitted static load. If loads are cycling (between
tension and compression) these loads should be reduced. For advice, consult the
manufacturer.
6.3 Measuring accuracy
Measuring error
The measuring error is obtained from the combined effects of accuracy and zero stability.
Reference conditions
S15 S25 S40 S80 S100
Flanges Flanges Flanges Flanges
20°C 40 barg 25 kN 38 kN 48 kN 99 kN 150 kN
100 barg 17 kN 19 kN 15 kN 20 kN 100 kN
230°C 32 barg 12 kN 18 kN 23 kN 45 kN 100 kN
52 barg 10 kN 15 kN 60 kN
Hygienic (all connections) Hygienic (all connections) Hygienic (all connections) Hygienic (all connections)
130°C 10 barg 5 kN 9 kN 12 kN 12 kN 18 kN
Product Water
Temperature +20°C / +68°F
Operating pressure 1 barg / 14.5 psig
1.6
1.4
1.2
1.0
0.8
0.6
0.4
0.2
0
MA_OPTIMASS_8000k_en_100817_4000921002_R02.book Page 33 Tuesday, August 17, 2010 2:08 PM