KROHNE OPTISWIRL 4070 EN - Manual (Page 61)

OPERATION
6
61
OPTISWIRL 4070
www.krohne.com 02/2013 - 4000150606 MA OPTISWIRL4070C R07 en
6.5.8 Menu item Setup (firmware version - gas)
Version gas
Level Designation Selection / entry Explanation
3.1 Set display
3.1.1 Error message
→
Display error
Yes ↑... Shows error messages in measuring mode in plain text
alternating with the measured values
No ↑...^ Shows a flashing cursor in the top left corner of the
display to indicate that there are errors.
3.1.2 Cycle.Disp.
→
Display measured values
Yes ↑... Cyclically display measured values in measuring mode
(6 s intervals)
No ↑...^ Do not display measured values cyclically
3.1.3 Code 1
→
Set security query 1 (menu)
Yes ↑... Activate access code:
→→→↑↑↑^^^
No ↑...^ Deactivate access code
3.2 I/O settings
3.2.1 4-20mA off
→
Current output 4-20 mA and error current
4-20mA ↑... Current output 4-20 mA
4-20/22E ↑... Current output 4-20 mA or error current 22 mA
4-20/3.55E ↑...^ Current output 4-20 mA or error current 3.55 mA
3.2.5 Function P
→
Pulse output
Yes ↑... Activate pulse output
No ↑...^ Deactivate pulse output
3.2.7 Totalizer
→
Totalizer
Tot. on ↑... Start Totaliser
Tot. off ↑...^ Stop totalizer (value is held)
3.2.8 Tot. Conf.
→
Configure totalizer
(available if Maes.Inst =
Volume, see menu item
1.1.3)
m 3
Unit ↑...^
Select totalizer unit for volume flow measurement
0000000000
m
3 ↑…↑...↑...^
Enter preset totalizer value
Reset Yes /
Reset No ↑...^
Reset totalizer
Do not reset totalizer/
Disp. off /
Disp. on ↑...^
Do not display totalizer
Display totalizer /
(available if Maes.Inst =
Norm. Vol., see menu
item 1.1.3)
m 3 norm
Unit ↑...^
Select totalizer unit for standard volume flow
measurement
0000000000
m
3 norm ↑…↑...↑...^
Enter preset totalizer value
Reset Yes /
Reset No ↑...^
Reset totalizer
Do not reset totalizer/
Disp. off /
Disp. on ↑...^
Do not display totalizer
Display totalizer /
MA_OPTISWIRL4070C_R07_en_150606_PRT.book Page 61 Wednesday, February 13, 2013 2:47 PM