KROHNE OPTIWAVE 5200 PROFIBUS - Manual (Page 5)

PROFIBUS PA
2
5
OPTIFLEX 2200 C
www.krohne.com 10/2013 - 4003066801 - MA OPTIFLEX2200C-PA-R01-en-
The device has 4 slots. The Analog Input Function Blocks use slot 1 (as a virtual module). The
user cannot change this setting. But the user can change the measurement name and unit for
each Function Block. Refer to the table that follows:
The calibration units are used as default units.
2.4 Technical data
INFORMATION!
If it is necessary to change the measurement name, change the channel parameter in the acyclic
PROFIBUS services.
Slot Module
type
Measurement name Unit
1 AI-FB Level (default setting) mm 1
Distance mm 1
Conversion L 1
Conversion Distance L 1
1 Default measurement unit
Hardware
Type PROFIBUS MBP interface. This interface agrees with IEC 61158-2 (bit rate
31.25 kbit/s);
voltage mode (MBP = Manchester-Coded, Bus-Powered)
Device power supply 9...32 V - bus powered; no additional power supply required
Polarity sensitivity No
Base current 14 mA
FDE Yes. The Fault Disconnection Electronics (FDE) operates independently.
Max. error current 20.5 mA
Start current after 10 ms Lower than base current
Software
Supported GSD KR014550.GSD
PA139700.GSD
Device profile PROFIBUS PA Profile V3.02; conformance class B, compact
Address setting Default: 126
Hardware DIP switch: 0…125
PROFIBUS service Set_Slave_Add: 0...125
Factory_Reset=2712: 126
Write protection Password and/or hardware switch
SAPs 2 × MS1 SAPs – acyclic interface to PLC
3 × MS2 SAPs – the number of MS2 Service Access Points is usually equal to
the maximum number of master class 2 tools
Function blocks 1 Physical Block
1 Level Transducer Block
4 Analog Input Function Blocks