KROHNE IFC 020 Converter EN - Manual (Page 45)

Installation and operating instructions IFC 020
6/2
HART operating tools / Device Description (DD)
The IFC 020 can be operated either via its local operator interface or by means of the HART
communicator or the CONFIG program. Both operating tools are available from KROHNE.
Operator control by means of the HART communicator requires a device description (DD) which
we can load for you into the communicator. We can, of course, also load the DDs of all
manufacturers who have filed their DDs with the HART Communication Foundation. If you wish to
use the IFC 020 in your operating tool, for example, please ask for the description of the HART
command used so that you can address the complete IFC 020 functionality via HART.
Electrical connection
Settings for use in interface operation
It is essential to blank off the final signal converter's electrical bus. To do this, solder up the
semicircular circuits of solder points S6 and S7 on the amplifier PCB. For further information refer
to sections 8.8 and 8.9.
The RS 485 protocol is available. Please contact your local Krohne supplier / company.
Krohne RS 485 Interface 6.2
For further information on setting the signal converter refer to chapters 4 and 5.
Fct. Parameter Krohne RS 485 Interface
3.08 COM KROHNE
ADRESS 000-239
BAUD RATE • 1200 • 0 9600
• 2400 • 19200
• 4800
Terminals:
IFC 020 E
IFC 020 K and F
Address, e.g.: