KYORITSU KEW Report Windows 8 User Manual

Installation manual for "kewreport

Advertising
background image

Installation Manual for "KEWReport"

This manual contains explanations how to install the special

application and the USB driver on Windows 8 PCs.

1. Installation of KEWReport

(1) The following should be checked before installing this

application.

  ・

To prepare your system for installation, please close

all open programs.

  ・

Be sure NOT to connect the instrument with the USB

until installation completes.

  ・

Installation shall be done with Administrator right.

(2) Insert the CD-ROM in your PC's CD drive. Then

following pop-up will appear at the upper right on the

screen. Left-click on this box.

(3) Click and select "Run install.exe" when the following box

appears.

  

If User Account Control dialog box appears, click "Yes".

  

If neither (2) nor (3) appears, run "install.exe" from the

CD.

(6) Click "Next".

(7) Confirm the information on installation, and then click"

Install" to start an installation.

(2) Click "Control Panel" -> "Device Manager".

(3) Click“O ther devices”and then right- click on

MODEL8212”.

  

Then click “Update Driver Software”.

(4) Select“Browse my computer for driver software".

(5) Check the box for“Include subfolders”, and then click

Browse”.

(6) Select the disk drive in which the CD resides and click OK.

  

If the CD is not inserted, close the window once by

clicking "Cancel" and select again after inserting the CD.

(6) When the following confirmation message appears,

after clicking“Next”, click“Install”.

(7) Select "Install this driver software anyway" if the

following warning window appears. (There is no

problem to continue installing because operation has

already been verified.)

(8) Install is completed when the wizard says "Windows has

successfully updated your driver software".

  

Click "Close".

(9) Click“Other devices”under the Device Manager, and

then right-click on“USB Serial Port”.

  

Then click“Update Driver Software”.

(8) Click "Finish" when "InstallShield Wizard Complete"

dialog box appears.

2. Installation of USB Driver

(1) Connect MODEL8212 and your PC with the USB cable

supplied with the instrument.

  

When the following window appears, install the driver

according to the following procedure.

(10) Repeat above step (3) through (6). Installation is

completed when the wizard says“Windows has

successfully updated your driver software”. Click

Close”.

(11) The following two icons will appear in the Device

Manager when the driver is successfully installed.

(4) When the following window appears, click "Next".

(5) Read through and understand the License Agreement

and click "I accept….", and then click" Next".

USB Driver Un-installation

When the installation of the USB driver is interrupted and

re-installation cannot be done, follow the

procedure below and delete the existing driver, and then

install it again.

(1) Connect your PC and the instrument with the USB cord.

(2) Click the“Control Panel”in the Start menu.

(3) Click“Device Manager”in the Control panel.

(4) Right click on“MODEL8212 USB”under "Other

devices".

(5) Click“Uninstall”to uninstall the USB driver.

(6) Remove the USB cord connecting your PC and the

instrument once, and connect them again.

(7) When“Found New Hardware Wizard”window appears,

follow the procedures described in“USB Driver

Installation”and install the driver.

92-2201

Advertising