SHIMPO DEG-2000 - Manual (Page 27)

25
7.3.7 Two-item judgment result output –– Output signal arrangement
The two-item judgment result output signal is output when “ITEM 1&2” is selected with
[JUDG OUT] in the set mode (6).
Note: “Item” refers to “ITEM” of DEG2000. The following table shows the output
signal arrangement of the DC input/output connector (refer to ◯
15 on page
7).
Pin No. Signal name Description
11 READY Turns on in measure mode during normal operation.
12 Error
Turns on when two signals are simultaneously input and
turns off when all signals are turned off.
13 Master OK Turns on when mastering result is OK.
14 Check input signal
Turns on when input signal is received and processing is
completed, and turns off when input signal is turned off.
15 All OK
Turns on at input of measure command when all items
are OK.
16 All NG
Turns on at input of measure command when any one
item is NG.
17 Item 1 -NG
18 +NG
19 OK1
20 OK2
21 OK3
22 OK4
23 OK5
24 OK6
25 OK7
26 Item 2 -NG
27 +NG
28 OK1
29 OK2
30 OK3
31 OK4
32 OK5
33 OK6
34 OK7
35 -COM
36 -COM
Output common line: 0 V