SUOMY MX Tourer - Manual (Page 28)

VISOR
The visor must be periodically cleaned and checked. The presence of dirt and/or deep
scratches on the visor’s surface may be due to abnormal light reflections or aberrations,
which diminish riding safety. Immediately replace the visor if such defects are noticed.
Movement
The visor must only be moved by adjusting the specific lifting flap on the bottom left hand side. Do
not move using other areas so as not to cause accidental damage (scratches or grooves) or
dirtying the field of view.
Opening the visor: push the visor outwards slightly using the lifting flap to detach the locking tab
from its housing in the seal, and then lift it up.
Closing the visor: to lock the visor into position, lower it until the tab is locked within the housing
in the seal.
There are two locking positions: an intermediate position and with the visor completely open.
The movement must always be completed up to the locking positions, which can be understood
because a slight click can be heard when the visor is properly locked. To unlock the visor from the
locked position it is sufficient to move it as described above, by slightly pressing down initially until
it is locked into place.
While riding the visor should never be left in the intermediate positions; it must always be
in one of the locked positions.
Disassembly See Figure 5 a/b
To remove the visor you must first remove the outer cover found on the cover of the visor
mechanism.
Using a screwdriver, and taking care not to damage the surface of the shell, unfasten the outer shell
until it is removed from the cover’s constraint points (A-B C). Then lift the visor until the fully open
26
Eng USE and MAINTENANCE
figure 5c
figure 5b
figure 5a