Milestone Basis+ 6.5 - Manual (Page 9)

8
so by clicking the Add SLC link and completing the SLC
registration steps before proceeding.
4. When ready, click the link representing the SLC.
5. For each device required on your system, click the Add
new MAC link and specify the device’s MAC address
and a description. The MAC address is a 12 digit
hexadecimal (example: 0123456789AF), referred to as
a “serial number” by some vendors. For information
about how to find the MAC address for a specific
device, refer to the manual for the device in question.
For video encoder devices, specify the number of
cameras to be used with the device.
Note that you are allowed to install only the number of
cameras listed on your product license sheet. For
example, a fully used four-port video encoder counts
as four cameras even though the cameras are
connected through a single device therefore a fully
used four-port video encoder will use four licenses.
6. Click Submit. The device is added to a list of devices
under the SLC in question.
7. If more devices are required, click the Add New MAC
link and repeat the process.
8. When ready, click the Get DLKs by e-mail link to have
DLKs for all the devices registered under the SLC e-
mailed to you.
Importing Device License Keys
The DLKs received through e-mail when registering the device
MAC addresses can be specified manually when adding
individual devices to XProtect Basis+.
However, you can avoid having to specify each DLK manually,
by saving the .dlk file attached to the e-mail at a location
accessible by the surveillance server—for example on a USB
stick or on a network drive—and then doing the following: