Prochem Everest 408-650, LP-HP - Manual (Page 43)

41
Maintenance
Service Schedule
* Or as often as required
** Change solution pump crankcase oil after the first 50 hours
***Change engine crankcase oil and filter after the first 25 hours
****Perform drive belt, pulley and hub maintenance after the first 25 hours of operation, and then again at 100 hours
*****If using AEON PD-XD synthetic lubricant, 1500 hours or every 2 years, whichever comes first.
****** Replace after 2 years or 2000 hours, whichever comes first.
Vacuum 50 hrs Retighten belts
Vacuum 100 hrs Check belt tension
Heat Exchanger Box 500 hrs Inspect & clean door guides (as needed)
Solution Pump 500 hrs Change oil**
Pulley Set Screws & Hub Cap Screws 500 hrs Check for proper torque values. Re-torque, if required****
Drive Pulley 500 hrs Inspect, clean and check for pulley groove wear****
Drive Pulley 500 hrs Check pulley alignment****
Drive Belts 500 hrs Replace
Drive Belts 500 hrs Check belt tension****
PCV Valve/hoses 750 hrs Inspect
Check Valve (Solution Outlet) 1000 hrs Inspect, clean, and repair, if needed.
Vacuum Exhaust Heat Exchanger 1000 hrs Inspect cores and remove debris.
Vacuum Pump 1500 hrs Drain, flush, and replace oil *****
Fuel Filter 1500 hrs Replace
Engine 2500 hrs Replace spark plugs.
Engine Yearly* Replace air cleaner elements.
Waste Tank Filters/Strainers Yearly Check for damage and blockage. Replace if needed.
Engine 2 years Flush radiator and change engine coolant.
Engine 2 years Replace radiator hoses and hose clamps.
Engine 2 years Replace timing belt. ******
Engine 5 years Replace ignition wires.
86352170 EVEREST