HP StoreAll Storage - Manual (Page 29)

Example 14 Dry run provisioning
hpsp_spt -cs -ctrlIp 10.20.12.101 -ap --dryRun
--------------------------------------------------
# Name WWN Drives Raid Size(GB)
--------------------------------------------------
1 HPIBX_VOL_1 N/A 5 5 1863.05*
2 HPIBX_VOL_2 N/A 6 5 2328.81*
3 HPIBX_VOL_3 N/A 6 5 2328.81*
4 HPIBX_VOL_4 N/A 6 5 2328.81*
--------------------------------------------------
*Approximate value
hpsp_spt -cs -ctrlIp 10.20.12.101 -ap --dryRun
Example 15 Actual provisioning
hpsp_spt -cs -ctrlIp 10.20.12.101 -ap
----------------------------------------------------------------------------------------------------
# Name WWN Controller Drives Raid Size(GB) Status
----------------------------------------------------------------------------------------------------
1 HPIBX_DAED6E3C041 00c0ff104cc000001da0495001000000 A 5 5 1861.12 OK
----------------------------------------------------------------------------------------------------
Summary:
1 Volume(s)
0 Spare(s)
Validating storage
Validate storage profile
Syntax
hpsp_spt -vs
hpsp_spt --validateStorage
Description
The --validateStorage command validates the storage configuration against the profile used
for configuring the storage. If the storage is not configured with any of the supported profiles, then
the validation of the configured storage fails with the appropriate error.
The validation scenarios include validating the configuration related to the number of spares,
drives, vdisks, volumes, RAID-level, host-access, and volume health
Example 16 Validate storage profile
# hpsp_spt -vs -ctrlIp 10.20.12.101 -usr manage -pwd \!manage
Validating with : 9320-SFF-EXP-300GB, 9320-SFF-STARTER-300GB
........
Valid Storage Configuration with profile: 9320-SFF-EXP-300GB, 9320-SFF-STARTER-300GB
Field support commands
WARNING! All these are hidden commands and should only be used by an HP field engineer.
Repairing a storage system
Syntax
hpsp_spt -rp [--dryRun]
hpsp_spt --repair [--dryRun]
Command reference and examples 29