HP EliteBook 8570w Mobile Workstation - Manual (Page 70)

IMPORTANT: You must temporarily disable SRT when changing RAID modes. Make the change
and then re-enable SRT. Failure to temporarily disable this feature will prevent you from creating or
changing RAID volumes.
NOTE: HP does not support SRT with self-encrypting drives (SEDs).
Removing the hard drive
NOTE: Before replacing a hard drive or changing the RAID volume see Intel Smart Response
Technology (select models only) on page 59 .
To remove a hard drive:
1. Save your work and shut down the computer.
2. Disconnect AC power and external devices connected to the computer.
3. Turn the computer upside down on a flat surface.
4. Remove the battery (see Inserting or removing the battery on page 43 ).
5. Remove the service door (see Removing or replacing the service door on page 57 ).
6. Loosen the two hard drive cover screws on the back of the hard drive (1).
7. Loosen the two smart card holder screws (2).
8. Open the smart card holder (3) to a vertical position.
9. Loosen the hard drive screw (1). Pull the hard drive tab (2) to the right to disconnect the hard
drive.
60 Chapter 8 Drives