HP LaserJet M3027 Multifunction Printer series - Manual (Page 55)

Print Quality menu
NOTE: Values shown with "(default)" are the factory-default values. Some menu items have no default.
Table 2-16 Print Quality menu
Menu item Sub-menu item Values Description
Set Registration Source All trays
Tray <X>: <contents>
(choose a tray)
Use Set Registration to shift the margin alignment to
center the image on the page from top to bottom and
from left to right. You can also align the image on the
front with the image printed on the back.
Select the source input tray for printing the Set
Registration page.
Test Page Print (button) Print a test page for setting the registration. Follow the
instructions that are printed on the page to adjust each
tray.
Adjust Tray <X> Shift from -20 to 20 along
the X or Y axes.
0 is the
default.
Perform the alignment procedure for each tray.
When it creates an image, the device scans across the
page from side to side as the sheet feeds from top to
bottom into the device.
Fuser Modes <Paper Type> Configure the fuser mode associated with each media
type.
Restore Modes Restore (button) Restore the fuser modes to the default settings.
Optimize High Transfer Normal (default)
Increased
Optimize print engine parameters to get the best
possible print quality for all jobs in addition to specifying
media type.
More Separation Off (default)
On
Line Detail Off (default)
On
Restore Optimize Restore (button) Reset all the Optimize parameters to the factory default
settings.
Resolution 300
600
FastRes 1200 (default)
ProRes 1200
Use this feature to select the print resolution.
REt Off
Light
Medium (default)
Dark
Enable Resolution Enhancement technology (REt),
which produces print output with smooth angles,
curves, and edges. All print resolutions, including
FastRes 1200, benefit from REt.
Economode Enabled
Disabled (default)
When Economode is enabled, the device prints with a
reduced amount of toner per page; however, the print
quality of the page is slightly reduced.
Toner Density Choose from a range of 1
to 5.
3 is the default.
Lighten or darken the print on the page. 1 is the lightest
and 5 is the darkest.
ENWW Use the Administration menu 43