Connecting controller and mixed drive enclosures, Additional cable requirements for drive enclosures, P2000 g3 msa system cable requirements – HP P2000 G3 MSA Array Systems User Manual
Page 25
HP P2000 G3 SAS MSA System User Guide
25
Connecting controller and mixed drive enclosures
P2000 G3 MSA System controller modules support cabling of 3Gb and 6Gb SAS link-rate LFF and SFF
expansion modules — in mixed fashion — as shown in
on page 32, and as further described
in
Additional cabling considerations
(below); the HP P2000 G3 MSA System Cable Configuration Guide;
and HP white papers (listed on the following page).
Additional cable requirements for drive enclosures
IMPORTANT:
•
When installing SAS cables, use only supported SAS 4x cables with connectors supporting your
application (6Gb, 3Gb, or both).
•
Mini-SAS to mini-SAS 0.5m cables are provided with each of the following drive enclosures (one per
expansion module): P2000 6Gb 3.5" 12-drive enclosure and D2700 6Gb drive enclosure.
•
If additional or longer cables are required, they must be ordered separately (see relevant MSA2000
G2 Quickspecs or P2000 G3 Quickspecs for your products).
•
The maximum cable length allowed in any configuration is 2m.
•
When expanding storage capacity, a maximum of eight enclosures — including the controller
enclosure — or one hundred forty nine (149) disk drives are allowed in the array.
P2000 G3 MSA System cable requirements
(below) and
on page 27 jointly describe cabling requirements and connection
combinations for P2000 G3 MSA System components. Components are labeled with back-end SAS data
rates and other relevant attributes. Simplified IOM face plates are shown.
Figure 1
P2000 G3 MSA System component connection combinations
below provides SAS cable requirements for connection combinations between MSA controller and
on page 27 provides details for cabling expansion modules.
NOTE:
Check Quickspecs addressing your respective product with regard to cabling. Quickspecs can be
found from your HP MSA products page
. Quickspecs links are located
on the right.
P2000 G3 Controller Enclosure
6Gbps
6Gbps
3Gbps
3Gbps
LFF
SFF
6Gbps
MSA70 3Gb IOM
P2000 6Gb IOM
D2700 6Gb IOM
MSA2000 3Gb IOM
D2700
P2000 6Gb
MSA70 MSA2000
D2700
P2000 6Gb
MSA70 MSA2000
D2700*
P2000 6Gb*
MSA70 MSA2000
MSA2000
*Cabling a 6Gbps drive enclosure behind the MSA70 3Gb drive enclosure will adjust its link-rate speed to 3Gbps
.
SAS2.0
SAS2.0
SAS1.1
SAS1.1