HP Photosmart 422 Portable Photo Studio - Manual (Page 43)

Solution Move the images from the camera's internal memory to the camera's
memory card. To do this, press OK to access the menu tabs. Navigate to the
Setup Menu, select Move Images to Card, then press OK.
You can also remove the memory card and then redock the camera. This forces
the HP Photosmart GoGo Photo Studio to read the internal memory of the camera.
The printer is plugged in, but it will not turn on.
Solution
●
The printer may have drawn too much power.
If the optional HP Photosmart Internal Battery is not installed in the printer,
unplug the printer power cord. Wait about 10 seconds, then plug the power
cord back in. Turn on the printer.
If the optional HP Photosmart Internal Battery is installed in the printer,
unplug the printer power cord if it is plugged in. Open the battery
compartment cover and remove the battery. Wait about 10 seconds, then
reinstall the battery. If desired, plug in the power cord. Turn on the printer.
● The printer may be plugged into a power strip that is turned off. Turn on the
power strip, then turn on the printer.
● The printer may be plugged into an incompatible power source. If you are
traveling abroad, make certain the power source in the country you are
visiting complies with the power requirements and power cord of the printer.
The optional HP Photosmart Internal Battery is installed in the printer, but the
printer will not turn on using battery power.
Solution
●
The battery may need to be charged. Plug in the printer power cord to
charge the battery. The printer battery light flashes green to indicate that the
battery is charging.
● If the optional HP Photosmart Internal Battery is installed in the printer,
unplug the printer power cord if it is plugged in. Open the battery
compartment cover and remove the battery. Wait about 10 seconds, then
reinstall the battery. If desired, plug in the power cord. Turn on the printer.
The optional HP Photosmart Internal Battery is installed in the printer, but it will
not charge.
Solution
●
Unplug the printer power cord if it is plugged in. Open the battery
compartment cover and remove the battery. Wait about 10 seconds, then
reinstall the battery. If desired, plug in the power cord. Turn on the printer.
Chapter 5
38 HP Photosmart 420 series GoGo Photo Studio