Changing the administration password using telnet, Select [1] from the main menu, Changing the clock setting using telnet – HP Tape Library Interface Manager Software User Manual
Page 40: Changing the clock setting using telnet 40, Changing the, Administration password using telnet
40 Management Operations
Chapter 3
Changing the Administration Password Using Telnet
If you intend to use the Web interface, then you must have a valid password
entered into the IM. To change the administration password:
Log into the IM via a Telnet session as described above in
“Accessing Telnet.”
1. Select [1] from the Main menu.
2. Select [1] from the Administration menu and type in the desired
password.
3. The password must contain exactly eight characters, using 1, 2, 3, and 4
only. If you do not want to have a password, then select [Enter].
Changing the Clock Setting Using Telnet
The clock is used to time stamp events in event and error logs. To change the
clock setting:
1. Log into the IM via a Telnet session as described in
2. Select
[1] from the Main menu.
3. Select
[2] from the Administration menu, then answer the questions about
today’s date.
4. Select [3] from the Administration menu, then answer the questions about
the current time.
The hour is given in military time, where the possible choices range from 0
through 23 hours after midnight. There is no option for handling daylight
savings time. Set your time zone as shown in the following table: