HP Hub & Switch Management for OV-UX - Manual (Page 52)

7-6
Managing Switches
Configuration
M
a
nagi
ng S
w
it
ches
Figure 7-2. HP ProCurve Switch 4000M Device View
Configuration - Fault Detection
The automatic fault detection feature protects your network from failing
because of problems such as network loops, defective cables, transceivers
and faulty network interface cards. Network problems are automatically
detected and entered in the Alert Log. The Fault Detection page lets you set
the sensitivity levels for the actions to be taken when a fault is detected on a
port in your network. Switches only have a sensitivity setting for logging
network problems. The sensitivity settings are:
High Sensitivity : The device will make an entry in the Alert Log (located in
the Status tab) when a network problem of any severity occurs.
Medium Sensitivity : The device will make an entry in the Alert Log when
serious network problems occur.
Low Sensitivity : The device will make an entry in the Alert Log only when
severe network problems occur. These are problems that may bring the
network down.