HP StorageWorks XP Remote Web Console Software - Manual (Page 92)

Table 35 PSF Command Operability for ShadowImage for Mainframe Volumes (continued)
Operability for ShadowImage for Mainframe Item
Active. Path status.
If the volume does not also belong to a TCz pair, 1 is
displayed with TCz info. Path number.
Table 36 (page 92) describes the PSF Read Subsystem Data and DEVSERV Sense Subsystem Status
results for SIz volumes.
Table 36 PSF and DEVSERV Results for ShadowImage for Mainframe Volumes
DEVSERV Sense Subsystem Status PSF Read Subsystem Data Pair Status
T-VOL S-VOL T-VOL S-VOL
PSEC-PNDG PPRI-PNDG PSEC-PNDG PPRI-PNDG Pending
PSECONDRY PPRIMARY PSECONDRY PPRIMARY Duplex
PSEC-PNDG PPRI-PNDG PSEC-PNDG PPRI-PNDG SP-Pend
SIMPLEX PPRI-SUSP PSEC-SUSP PPRI-SUSP V-Split
SIMPLEX PPRI-SUSP PSEC-SUSP PPRI-SUSP Split
PSEC-SUSP PPRI-SUSP PSEC-SUSP PPRI-SUSP Suspend
PSEC-PNDG PPRI-PNDG PSEC-PNDG PPRI-PNDG Resync
NOTE: PPRIMARY and PSECONDRY indicate that the volume is in the duplex state.
Figure 39 (page 92) shows an example of the DEVSERV command.
Figure 39 DEVSERV Command
97244 13:04:37.39 DS P,DE80,1
97244 13:04:38.57 IEE459I 13.04.37 DEVSERV PATHS 692
692 UNIT DTYPE M CNT VOLSER CHPID=PATH STATUS
692 RTYPE SSID CFW TC DFW PIN DC-STATE CCA DCA
692 DE80,33903 ,0,000,DKDE80,54=+ 1C=+ D4=+ 9C=+
692 0080 Y YY. YY. N PPRIMARY 00 00
Adding Pairs Using PPRC Commands
The CESTPAIR and PPRCOPY ESTPAIR commands are equivalent to the SIz add pair operation.
The CESTPAIR and PPRCOPY ESTPAIR commands must be issued to the S-VOL of the pair being
created, and the T-VOL must be offline to the host before these commands are issued.
This section describes the parameters and examples of the CESTPAIR and the PPRCOPY ESTPAIR
command.
CESTPAIR (Adding Pairs)
Table 37 (page 93) lists and describes the CESTPAIR command parameters that can be used when
you create SIz pairs.
92 Performing ShadowImage for Mainframe Pair Operations Using PPRC