HP Integrity NonStop H-Series - Manual (Page 34)

Interfacing With the Open SCSI I/O Process (IOP)
Open SCSI for Fibre Channel Controller Integrator’s Manual for HP Integrity NonStop NS-Series Servers—
3- 18
File-System (FESTATUS) Error-Code Values
200 FEOWNERSHIP Check for one of these causes:
•
The backup IOP received a request that should
have gone to the primary IOP.
•
The controller port for this processor is not enabled.
201 FEPATHDOWN Check for one of these causes:
•
The current path to the specified device is down.
•
A request specified a path that is down.
210 FEOWNABORT Ownership changed during an I/O operation. This error
code is normally returned if a processor fails during an
I/O operation.
213 FECHPARITY A parity error was detected on the I/O control path or
channel.
214 FECHTIMEOUT A channel timeout occurred.
218 FEINTTIMEOUT A timeout occurred during a wait for an interrupt from an
I/O operation.
219 FEILLRECON There was an illegal reconnect sequence on the
channel.
221 FEHANDSHAKE A controller handshake error occurred.
222 FEBADEIOSTAT Bad status was returned from an execute I/O (EIO)
command.
223 FEBADIIOSTAT Bad status was returned from an interrogate I/O (IIO)
command.
224 FECTLERR An unspecified controller error occurred.
230 FECPUPON The processor experienced a power-on cycle.
231 FEIOPON The I/O subsystem experienced a power-on cycle.
3504 FEREQUESTUNSUPPORTED
This error code is mapped by the file system to an FEINVALOP (2) error code.
The application should never see this error code, and all causes of this error code
and all places in this manual where this error code is specified should be
translated into FEINVALOP.
Note. For a complete description of the Guardian file-system error messages, error codes with
their meanings and the cause, possible effect on the system, and recommended recovery
action for each message, refer to the Guardian Procedure Errors and Messages Manual.
Table 3-6. File-System Error Codes and Their Meanings (page 3 of 3)
Error
Code Corresponding
FESTATUS Literal
Meaning or Error Cause