HP Designjet T610 Printer series - Manual (Page 132)

NOTE: Whenever you update the printer’s firmware, the paper advance calibration values are
reset to factory default, see Update the firmware on page 104 .
CAUTION: Transparent papers and films must be calibrated using Image Quality Maintenance menu
icon , then Paper advance calibration > Adjust paper advance, from step four in the Recalibrating
the paper advance procedure.
Recalibrating the paper advance procedure
1. Press the Menu key to return to the main menu and select the Image Quality Maintenance menu
icon , then Paper advance calibration > Calibrate paper advance. The printer automatically
recalibrates the paper advance and prints a paper advance calibration image.
2. Wait until the front panel displays the status screen and re-print your print.
NOTE: The recalibration procedure takes approximately three minutes. Do not worry about the
paper advance calibration image. The front-panel display shows any errors in the process.
If you are satisfied with your print continue using this calibration for your paper type. If you see
improvement in your print, continue with step three. If you are dissatisfied with the recalibration,
return to the default calibration, see
Return to default calibration on page 122 .
3. If you would like to fine-tune the calibration or are using a transparent paper, press the Menu key
to return to the main menu and select the Image Quality Maintenance menu icon , then Paper
advance calibration > Adjust paper advance.
4. Select the percentage of change from -100% to 100%. To correct light banding, decrease the
percentage. To correct dark banding, increase the percentage.
5. Press the OK key on the front panel, to save the value.
6. Wait until the front panel displays the status screen and re-print your print.
Return to default calibration
Returning to the default calibration sets all the corrections made by the paper advance calibration to
zero. To return to the default paper advance calibration value, you must reset the calibration.
1. Press the Menu key to return to the main menu and select the Image Quality Maintenance menu
icon , then Paper advance calibration > Reset paper advance
2. Wait until the front panel displays the operation has completed successfully before pressing the
back key to return to the main menu.
122 Chapter 12 Troubleshooting paper issues ENWW
Paper issues