Manually setting up an hp-ux managed system, Configuring snmp to send traps to the cms – HP Systems Insight Manager User Manual
Page 24
If iCap information is desired, also install:
▲
B9073BA version 08.01.01 iCAP for HP-UX
2.
Ensure the managed system software is installed.
To verify that the minimum required software is installed, log in to the remote system, and run the
following command:
$ swlist –l bundle T1471AA B8465BA OpenSSL
To verify that the optional providers and HP System Management Homepage are installed, run commands
such as:
$ swlist –l bundle LVMProvider WBEMP-LAN-00 SysMgmtWeb SysFaultMgmt
OnlineDiag
3.
Acquire and install the managed system software if not previously installed.
The SSH and WBEM bundles are included on the HP-UX Operating Environment and Application Release
media, as well as part of the Systems Insight Manager HP-UX depot downloaded from
For the WBEM providers, see
.
After you have obtained the depots containing the software, you can install then from the managed
system:
$ swinstall –s <depot_location> OpenSSL
NOTE:
B8465BA and B9073BA version 08.01.01 depends on OpenSSL, so you must install OpenSSL
first.
$ swinstall –s <depot_location> T1471AA
$ swinstall –s <depot_location> B8465BA
$ swinstall –s <depot_location> <names of WBEM providers being installed>
After you have verified that the correct management software is installed on your managed systems, continue
to Chapter 4
> to finish the configuration from the Systems Insight Manager user interface.
Manually setting up an HP-UX managed system
Although chapters 4-7 explain how to finish configuring managed systems from the Systems Insight Manager
GUI, this section describes how to perform some of these same steps from the command line for HP-UX
systems. You do need to first supply credentials and discover the systems, as described in Chapter 4
and Chapter 6
. Then you can do the following actions from the command line, if
desired.
You can use the Systems Insight Manager Configure or Repair Agents tool to configure HP-UX managed
systems simultaneously, or you can configure each managed system manually.
Configuring SNMP to send traps to the CMS
•
On the managed system, add the full host name or IP address of the CMS as a trapdest in the following
file:
/etc/SnmpAgent.d/snmpd.conf
trap-dest: hostname_or_ip_address
•
Stop the SNMP Master agent and all subagents with the command:
/sbin/init.d/SnmpMaster stop
•
Restart the SNMP Master agent and all subagents with the command:
/usr/sbin/snmpd
24
Setting up managed systems