HP Color LaserJet 5550 Printer series - Manual (Page 69)

7. Press to select TRAY BEHAVIOR.
8. Press to highlight MANUAL FEED PROMPT.
9. Press to select MANUAL FEED PROMPT.
10. Press or to select ALWAYS or UNLESS LOADED.
11. Press to set the behavior.
12. Press M
ENU
.
To set the printer default for PS Defer Media
1. Press M
ENU
to enter the MENUS.
2. Press to highlight CONFIGURE DEVICE.
3. Press to select CONFIGURE DEVICE.
4. Press to highlight SYSTEM SETUP.
5. Press to select SYSTEM SETUP.
6. Press to highlight TRAY BEHAVIOR.
7. Press to select TRAY BEHAVIOR.
8. Press to select PS DEFER MEDIA.
9. Press or select ENABLED or DISABLED.
10. Press to set the behavior.
11. Press M
ENU
.
PowerSave Time
The adjustable PowerSave Time feature reduces power consumption when the printer has
been inactive for an extended period. You can set the length of time before the printer goes
into PowerSave mode to 1 MINUTE, 15 MINUTES, 30 MINUTES, or to 60 MINUTES, 90
MINUTES, 2 HOURS, or 4 HOURS. The default setting is 30 MINUTES.
Note The printer display dims when the printer is in PowerSave mode. PowerSave mode does not
affect printer warm-up time unless the printer was in PowerSave mode for more than 8 hours.
To set PowerSave Time
1. Press M
ENU
to enter the MENUS.
2. Press to highlight CONFIGURE DEVICE.
3. Press to select CONFIGURE DEVICE.
4. Press to highlight SYSTEM SETUP.
5. Press to select SYSTEM SETUP.
6. Press to highlight POWERSAVE TIME.
7. Press to select POWERSAVE TIME.
8. Press or to select the appropriate time period.
9. Press to set the time period.
10. Press M
ENU
.
ENWW Changing printer control panel configuration settings 55