HP PCIe IO Accelerators for ProLiant Servers User Manual
Page 29
Linux environments 29
iv.
If the HP IO Accelerator Management Tool is installed, uninstall it.
o
To uninstall 2.x driver, run the following command:
modprobe –r iomemory_vsl
If you have not unmounted any filesystems or RAID volumes that are using the IO Accelerator, this
command might fail.
3.
To uninstall the 2.2 packages, run the following commands in order.
o
To uninstall the HP IO Accelerator Management Tool:
# rpm -qa | grep accelerator
fio-firmware-ioaccelerator-43674.2-1.0
hp_io_accelerator_management_tool-gui-2.3.0.1859-1.1
hp_io_accelerator_management_tool-jre-2.3.0.1859-1.1
# rpm -e fio-firmware-ioaccelerator-43674.2-1.0
# rpm -e hp_io_accelerator_management_tool-jre-2.3.0.1859-1.1
# rpm –e hp_io_accelerator_management_tool-gui-2.3.0.1859-1.1
o
To uninstall the Libfusion RPM packages:
# rpm -qa | grep libfusion
libfusionjni-1.1.0.9-1.0
# rpm -e libfusionjni-1.1.0.9-1.0
o
To uninstall the Fio driver RPM packages:
# rpm -qa | grep fio
fio-util-2.2.0.82-1.0
fio-smis-1.1.0.9-1.0
libfio-dev-1.1.0.9-1.0
fio-common-2.2.0.82-1.0
fio-snmp-agentx-1.1.0.9-1.0
libfio-doc-1.1.0.9-1.0
fio-snmp-mib-hp-1.1.0.9-1.0
libfio-2.2.0.82-1.0
fio-sysvinit-2.2.0.82-1.0
# rpm -e fio-util-2.2.0.82-1.0
# rpm -e fio-smis-1.1.0.9-1.0
# rpm -e libfio-dev-1.1.0.9-1.0 libfio-doc-1.1.0.9-1.0
# rpm -e fio-common-2.2.0.82-1.0 fio-snmp-agentx-1.1.0.9-1.0
# rpm -e fio-snmp-mib-hp-1.1.0.9-1.0
# rpm -e libfio-2.2.0.82-1.0
# rpm -e fio-sysvinit-2.2.0.82-1.0
o
To uninstall the iomemory RPM packages:
# rpm -qa | grep iomemory
iomemory-vsl-source-2.2.0.82-1.0
iomemory-vsl-2.6.18-194.el5-2.2.0.82-1.0
#
# rpm -e iomemory-vsl-source-2.2.0.82-1.0