GE 45255 Quick Start Guide User Manual
Do not return this product to the store, Quickstart guide
Charging
Light
monitor
AC power
RED=Charging GREEN=Full charge
battery
compartment
(4 -AA)
power
switch
power
LED
AC power
DO NOT
RETURN THIS
PRODUCT TO
THE STORE!
If you have any problems or questions,
contact our expert TECH SUPPORT TEAM at
1-800-654-8483, option 1
Monday–Friday, 8–5pm CST
For the most up-to-date product support, accessories,
electronic (PDF) format manuals and more, visit
www.jascoproducts.com/support
45255-QS ver1
is a trademark of General Electric Company and is under license by Jasco Products Company LLC, 10 E. Memorial Rd., Oklahoma City, OK 73114
PACKAGE CONTENTS
(1) Monitor
(1) Charging cradle
(1) Camera
(2) AC power supply adapters
(1) Mini USB cable
(1) CD (PC Monitoring Software)
(1) Camera wall plate and mounting hardware
QUICKSTART GUIDE
FOR YOUR CONVENIENCE
The camera is already paired to channel 1 of the monitor
at the factory. No additional programming is needed!
The monitor will automatically scan for the camera and
then the video will appear on the screen. The built-in
speaker will automatically broadcast live audio from the
camera. Volume is adjusted using the buttons located on
top of the monitor.
It’s that simple!
For more detailed information on the features and operation of this product,
please refer to the user’s manual included in the package.
For AC Adapter Power:
Plug AC power adapter into the base
of the camera, and into an electrical
outlet.
AC Adapter into Monitor:
Plug AC power adapter into the
right side of the monitor, and into
an electrical outlet. Slide the power
switch on the left side of the monitor
to the ‘on’ position. The charging
LED will glow near the power input.
AC Adapter into Cradle:
Plug AC power adapter into the
rear of the charging cradle, and
place monitor into the cradle. Slide
the power switch on the left side
of the monitor to the ‘on’ position.
The charging LED will glow near the
power input.
For Battery Power:
Push the tab to release the cover,
and insert 4 AA batteries, following
the polarity diagram shown inside
the compartment.
Slide the power switch to ‘ON—the
power LED will glow green below the
OFF position. A fl ashing POWER LED
indicates batteries are low.
Position the camera at the best angle
for viewing—tabletop or wall mount—
and in a dry, protected location
(indoors.)
CAMERA OPERATION
MONITOR OPERATION
NOTE: Depending on the current state of the battery, it can take
up to 6 hours to fully charge the monitor. A fl ashing POWER LED
indicates a low battery.
power
switch
TABLETOP
WALL
MOUNT