BMR Suspension BK010 - Manual

Front Radius Rod Bushings
BK010
Required Tools:
• Hydraulic jack and 2 stands (lift optional but recommended)
• Wrenches – 18mm
• Sockets – 18mm, 21mm
• Pry-bar
• Brass hammer
Installation:
1. Lift vehicle and support with stands
under the rocker jack points or K-
member.
2. Remove both front wheels/tires.
3. Remove the (2) Phillips head screws
and (10) plastic clips that retain the
plastic inner wheel well. A small
screwdriver will “pop” the clips out
by prying the center of the clip out
then removing the clip. See Image 1.
4. Using an 18mm socket and wrench, remove the inner mounting bolt on the lower
radius rod. See Image 2.
5. Using a 21mm socket, remove the outer ball joint nut. See Image 3 above.
6. Knock the ball joint loose from the spindle using a brass hammer or equivalent.
7. Remove radius rod.
1