Cyron Lighting AGS103 Safety Skirt - Manual

AGS102 / AGS103 Safety Skirt
Thank you for choosing CYRON products! At CYRON we are committed to
provide the latest lighting technology without any compromises.
To install this kit you should be familiar with basic electrical wiring. Should
you need help installing the system you may contact CYRON customer
support at 818-772-1900 x106 or [email protected]. Alternatively, you
may seek assistance from an authorized CYRON dealer or your local
motorcycle shop.
COMPONENTS:
1x 2-level-circuit 2x LED Lights (AGS103 has three) 1x Butt splice connector
2x Scotchlock
®
connectors 1x Ring terminal 15x Wire Ties
TOOLS NEEDED:
Wire stripper, Wire cutter, Crimper, Pliers, Electrical tape.
NOTE: You may choose to solder and shrink tube the connections if you so desire.
OVERVIEW:
CYRON Safety Skirt systems are designed to augment the existing running lights & brake lights on touring motorcycles, in
particular the models with hard bags. AGS103 system has a third light which is suited for bikes with trunks or rear fenders
suited for lights inside the fender.
a
AGS102 and 103 are not DOT approved and are not intended to replace the running lights on a vehicle.
INSTRUCTIONS:
Pay special attention to placement of the wires. Avoid moving parts or coming in direct contact with the
engine, tires, pipes and other objects that may damage the wires/lights. Use wire ties to secure all the wires.
To prevent voiding factory warranty, DO NOT CUT factory wiring. Use Scotchlok ®
connectors to tap into
the existing wires.
1. Light Placement:
See Figure One. The lights will mount to railings supporting the hard bags using zip ties. Use three
zip ties to secure the light and one on the wire immediately after the light. Place the zip tie between LEDs as shown in
the figure. Putting zip tie
on top of the LED can
damage the internal circuit.
Avoid mounting the lights
directly on the bags since
the bags will be removed at
times. If you choose to
mount on a removable
object, a connector should
be used to facilitate
removing the bags and
disconnecting the wires.
Consult CYRON technical support for recommendations.
2. AGS103R:
AGS103 system has a third light that can be mounted somewhere in the middle of the two saddle bags.
Ideal places could be on the bottom of the trunk rail or inside some custom wide fenders.
NOTE: Installing lights inside the rear fender should be done with extreme care. Moving tire and debris may damage
the lights over time if not installed properly. Contact CYRON Tech Support or an authorized CYRON dealer for help.
Keep in mind using the third light is optional. Not installing the third light will not affect the functionality of the other
two lights.
3. Find factory wires:
For this installation you need to find the wires for running lights and brake lights near the rear
wheel. The colors and location of the wires will vary depending on the make/model of the bike. You may consult your
bike user manual for color codes.
___ Figure One ___