EOTech MIPIM (AN/PEQ-16B) - Mini Integrated Pointer Illuminator Module - Manual (Page 59)

3-7
3.3 CORRECTIVE MAINTENANCE - Continued
5. Replace the battery cap and/or battery cap lanyard as
necessary.
6. Stretch smaller eye of the battery cap lanyard over the
post on the battery cap.
7. Simultaneously stretch and pull the larger eye of the
battery cap lanyard over the battery cap threads. Work
the lanyard until it is seated neatly in the groove closest to
the MIPIM housing.
8. Stretch the o-ring over the battery compartment threads
and slip it into its retaining groove.
9. Reinstall the battery cap and tighten.
Replacing Safety Screw
1. Remove safety screw by using a 3/32 inch hex head
wrench. Turn counterclockwise.
2. Install replacement safety screw in the lockout or storage
location. Using a 3/32 inch hex head wrench, turn
clockwise to tighten.
Replace Reflector Assembly Cover / O-Ring
NOTE
A new reflector assembly o-ring should be
installed whenever the Reflector Assembly Cover
is replaced.
1. Flip the White Light Lens Cap to the side of the White
Light Illuminator.