Equus 3140 - Scan Tool CanOBD2&1 Kit - Manual (Page 8)

6 CanOBD2&1
E
About the CanOBD2&1 Scan Tool
ADJUSTMENTS/SETTINGS AND DTC LIBRARY
Adjustments and settings can be made only when the
CanOBD2&1 Scan Tool is NOT connected to a vehicle.
To enter the MENU Mode:
1. With the CanOBD2&1 Scan Tool OFF,
press and hold the UP button, then
press and release the POWER/LINK
button.
■ The Setup Menu displays.
2. Release the UP button.
DO NOT release the UP button until the Setup Menu is
visible on the display.
3. Make adjustments and settings as described in the following para-
graphs.
Adjusting Display Brightness
1. Use the UP and DOWN but-
tons, as necessary, to highlight Adjust
Brightness in the Setup Menu, then
press the ENTER/LD
button.
■ The Adjust Brightness screen dis-
plays.
■ The Brightness field shows the cur-
rent brightness setting, from 0 to 43.
2. Press the UP button to decrease
the brightness of the display (make the
display darker).
3. Press the DOWN button to increase
the brightness of the display (make the
display lighter).
4. When the desired brightness is obtained, press the ENTER/LD
button to save your changes and return to the Setup Menu.
Using the Backlight
1. Use the UP and DOWN but-
tons, as necessary, to highlight Display
Backlight in the Setup Menu, then
press the ENTER/LD
button.
■ The Display Backlight screen displays.
2. Press the UP or DOWN button,
as necessary, to select the desired
backlight mode, either ON or OFF.