Innovate Motorsports MTX-L User Manual
Page 5
5
2.1.1
Single Innovate Device Relay Wiring Instructions
2.2
Mounting and Routing
The MTX-L gauge fits in any standard 2 1/16” (52mm) gauge pod. Mounting
of the gauge should be done in such a manner that the cables are not being
forcefully pulled and strained from the gauge itself. Route the sensor cable
avoiding contact with the exhaust pipe and other hot sources that could melt
the cable. Also avoid routing the sensor cable near ignition components or
other sources of RF (radio frequency) and EMI (Electromagnetic
interference) noise.
The MTX-L gauge is splash resistant (not water proof) and can be
mounted so that it is exposed to the outdoor elements. The MTX-L should
not be submerged and special consideration should be taken to protect the
gauge from direct water spray (water coming from a pressurized source.)
When replacing the bezel and/or gauge face verify that the o-ring is properly
seated.