MBRP S6210 - Manual (Page 4)

10. Install the Passenger Side Tail Pipe from the rear of the truck, over the
axle and attach to the lower outlet of the Muffler. Install the tail pipe
hanger into the OEM hanger to complete the driver’s side. See Figure 13.
11. Install the provided Clamps around the pipes where needed. Adjust the
Tail Pipe and check along the whole length of the exhaust system to
ensure that there is adequate clearance around the fuel and brake lines
or any wiring. If any interference is detected relocate or adjust.
8. Make sure the complete exhaust is in place before tightening the clamps.
Start at the front of the exhaust system and begin tightening all
Figure 13
connections.
9. Install and adjust Tips to suit. Using a 17mm wrench tighten lock bolt located on Tip.
Congratulations! You are ready to begin
enjoying the improved performance and driving
experience of your MBRP Inc. performance
exhaust system. We hope you enjoy your
purchase.
S6210 © 12/05
Page 4 of 4