MBRP S5076 - Manual (Page 2)

S5076 © 01/13 PAGE 2 OF 3
Removal of Stock System
1. Apply a penetrating lubricant liberally to all exhaust fasteners,
hangers and rubber insulators.
2. Remove the nuts from the studs holding the front flange together and
disconnect the exhaust system. Refer to Figures 1.
3. Remove the hangers from the rubber insulators and remove the exhaust
from the vehicle. Refer to Figures 2 to 3.
Installation of MBRP Inc. Performance Exhaust
1. Install the Extension Pipe to the existing flange. Attach the hanger to the
rubber insulator located on the frame. Leave the hardware loose enough for
some adjustment. Refer to Figure 4. Note the Extension Pipe is the correct
length for the crew cab long bed (167” wheelbase). The Extension Pipe will
require trimming for other models. Refer to the diagram below.
2. Slide a 3 1/2” Clamp onto the rear of the Extension Pipe. Install the
Muffler onto the Extension Pipe. Refer to Figure 5.
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5