MBRP S5064 - Manual (Page 2)

S5064 © 03/11 PAGE 2 OF 3
Removal of stock system:
1. Apply a penetrating lubricant liberally to all exhaust fasteners,
hangers and rubber insulators.
2. Remove the nuts from the studs holding the front flange together
and disconnect exhaust system. Refer to Figure 1.
3. Remove the hangers from the rubber insulators and remove the
exhaust from the vehicle.
4. If a hoist or hydraulic lift is not being used the tail pipe may need
to be cut to clear the rear axle. Refer to Figure 2
5. The studs located in the exhaust flange must be removed.
This can be accomplished using a hammer. The studs will be
replaced by hardware supplied with the system.
Installation of MBRP Inc. Performance Exhaust:
1. Loosely attach the Extension Pipe to the flange using the fasteners
provided. Attach the Extension Pipe hangers to the rubber
insulators located on the frame. Refer to Figure 3.
2. Slide a 3” Hanger Clamp and a 3” Clamp if required onto the
rear of the Extension Pipe. Install the Muffler onto the Extension
Pipe and install the hangers into the factory rubber insulator
located above the rear of the Muffler. Refer to Figure 4.
Figure 1
Figure 2
Figure 3
Figure 4