Schumacher INC-7A-OBD - Manual (Page 4)

• 4 •
5. FEATURES
1. Charging Status Lights
2. Internal Battery Status Lights
3. Internal Battery Status Test Switch
4. OBD (On Board Diagnostic) Connector with a 6 Foot Cable
5. Internal Battery Charger Plug
6. 12V DC Power Outlet (On Back, Not Shown)
7. Velcro Strap (not shown)
4
1 2
3
5
6. CHARGING THE INTERNAL BATTERY OF THE MEMORY SAVER
IMPORTANT: CHARGE IMMEDIATELY AFTER PURCHASE, AFTER EACH USE
AND EVERY 30 DAYS TO KEEP THE MEMORY SAVER’S INTERNAL BATTERY
FULLY CHARGED.
6.1 Use of an improper extension cord could result in a risk of fire and electric shock. When
an extension cord is used, make sure:
• That the pins on the plug of the extension cord are the same number, size and shape
as those of the plug on the memory saver charger.
• That the extension cord is properly wired and in good electrical condition.
• That the extension cord has a wire size of 18 gauge (AWG) [0.82 mm 2 ] or larger and
is 50 feet (15.24 meters) long or less.
6.2 To reduce the risk of electric shock, unplug the memory saver charger from the outlet
before attempting any maintenance or cleaning.
6.3 When charging the internal battery, work in a well ventilated area and do not restrict the
ventilation in any way.
6.4 LED Indicators:
To check the internal battery’s charge status, press the Battery Status button on the front
of the memory saver.
The LED lights will indicate the charge level as follows:
• A red LED indicates a 50% or less charge and you should immediately recharge
the memory saver.
• A yellow LED indicates a 50 to 75% charge. The memory saver may be used but
should be recharged as soon as possible.
• A green LED indicates the internal battery is fully charged.
• The CHARGING (red) LED indicates the memory saver is charging (connected
to an AC power source.) At full charge, the CHARGED (green) LED will light.
6.5 Charging the Internal Battery using the Built-In Charger:
1. To charge, plug an 18 gauge (AWG) or larger extension cord into the charger
plug on the left side of the memory saver. (Extension cord not included; must be
purchased separately.)
2. Plug the extension cord into a 120V AC electrical wall outlet.