Racing Electronics SC200 - Manual (Page 37)

If you want to program tones for several frequencies during
your search, follow these steps:
n After you program a frequency and a CTCSS
tone or CDCSS tone into a channel, the Search
Mode is changed to Search Hold Mode. To
activate the Search Mode press
/BAND.
n If you decide to cancel the CTCSS Tone Search
Mode or CDCSS Tone Search Mode while you
are searching for frequencies, press and hold
until you hear two short beeps and the
CTCSS
indicator or DCS indicator turns off.
Changing a CTCSS/CDCSS Tone
1. Press to activate the Subaudible Tone function.
2. Select the channel you want to change.
3. Press .
4. Enter the new CTCSS tone or CDCSS tone using VFO
control,
or .
If you make a mistake while using your keypad, press
and enter the tone again.
35
Change per 1sec.