Sol UniStar LED - Manual

Toll: 800.959.1329 Tel: 772.286.9461
www.solarlighting.com
UniStar™ Quick Install Guide
3 4
Drill thru one side approx. 15/16” to 31/32” ( 24.4 mm) hole
at each location the UniStar is to be installed. Ensure there is
room behind hole to access and connect wiring.
Access/mounting hole
for LED UniStar
Insert each UniStar into drilled hole and attach retainer ring
(not provided) or other securing hardware device that may be
provided.
Attached source wires by inserting matching plugs together
to secure. Note: Red is Positive (+). If no matching plugs
are available, strip UniStar plugs to expose bare wires and
using appropriate connectors, connect the UniStar LED wires
to the source wires.
Remove each UniStar light from packaging. Proper fire
enclosure shall be provided by end user. Operating Voltage :
3-4 VDC Note: Red wire is positive (+) and Black wire is
Negative (-).
UniStar LED Light
Red Wire: Positive (+)
Black wire: Negative (_)
1 2
UniStar connection plugs
Red Wire: Positive ( + )
Black wire: Negative (
_
)
Retainer ring
Install the Sol UniStar LED in accordance with all applicable codes. Though designed for ease of installation, it is recommended
that the UniStar LED be installed by a licensed electrician.
Max. Thickness = 1/2”
UniStar connection plugs
IM-UNISTAR-01-EN-rev.0713