Posey Door Guard/Do Not Enter Alarm - Manual (Page 2)

Posey Company • 5635 Peck Road, Arcadia, CA 91006-0020 USA Phone: 1.800.447.6739 or 1.626.443.3143 • Fax: 1.800.767.3933 or 1.626.443.5014 • Web: www.posey.com
Washing Instructions:
Machine wash hot, tumble dry low.
door Guard and do Not Enter Banner may
be laundered. The alarm surface may be
wiped clean with a mild disinfectant.
Alarm Testing Instructions
NeVeR leave a patient unattended without
first testing the alarm to ensure it is
functioning as intended.
To test the Personal Alarm, remove the
magnet from the faceplate. The alarm should
sound.
Battery Replacement
1. Make sure magnet is attached to the
metal plate.
2. Press down on arrow and slide the battery
door open.
3. Remove the battery
from the
compartment and
hold in one hand with
thumb on the terminal
cap. Battery
connection wires
should be away from
the thumb. dO NOT pull the terminal cap
wires.
4. Use thumb to push the terminal cap up,
off the battery (Fig. 1).
5. Connect terminal cap to the new battery.
Make sure the battery is securely
connected to the terminal cap and insert
into alarm unit.
Maintaining Hook and Loop:
If hook and loop does not adhere, it is most
likely due to collection of dust and lint. Clean
hook by brushing with a stiff brush.
Storage Instructions
• This device is designed for use in normal
indoor environments.
• This device may be stored in ambient
warehouse temperatures at normal humidity
levels. Avoid excess moisture or high humidity
that may damage product materials.
Disposal
dispose of per your facility
policy or applicable local code for
BIOHAZARdOUS material.
Limited Lifetime Warranty:
The Posey Company warrants to the original
purchaser, the alarm unit to be free from
defects in materials and workmanship for the
life of the unit. Warranty void if unit is opened,
damaged, or submerged. This warranty gives
you specific legal rights, and you may also have
other rights, which vary from state to state.
Posey ® Door Guard/Do Not Enter Alarm (Cont.)
information.
6. Slide battery door closed.
7. Test system to verify it is working
properly before leaving patient
unattended.
• Battery can explode or leak and cause
damage to alarm or skin if installed
backwards, disassembled, fully discharged
or exposed to water, fire or high
temperatures.
• alWaYS install a completely new battery
when the low battery light illuminates.
• Installing battery incorrectly can cause
battery to utilize more power than normal
and discharge sooner, causing possible
corrosion. Take care when installing new
battery.
Fig. 1
ALARM
FRONT
ALARM BACK
TONE
SELEC
TOR
3
4
1
7
2
6
10
9
8
1. Battery Door
2. Metal Plate
3. Magnetic Block
4. Removable Key Ring
5. Plastic Hook
6. Tone Selector
7. Low Battery Light
8. Sound Dampening Plug
9. Hook Patch (on alarm)
10. Loop Patch (adhesive)
5