AEG LAVAMAT 72630 - Manual (Page 33)

Operating Instructions
33
Water runs out under
the washing machine.
The screw connection on the
intake hose is leaky. Tighten the intake hose
screw connection.
The drainage hose is leaky.
Check the drainage hose and
replace it if necessary.
The washing solution pump
cover is not correctly closed.
Close cover correctly.
Washing stuck in the filling
door.
Stop the program, remove
washing from the filling
door, start a new program.
The emergency drain hose is
not properly shut off or it is
not water-tight.
Shut the emergency drain
hose off properly (see section
"Performing an Emergency
Drain"). Call your after-sales
service if the emergency
drain hose is not water-tight.
Conditioner not added,
compartment
æ for
the conditioners is full
of water.
The conditioner insert in the
compartment for the condi-
tioners is not correctly at-
tached or is blocked.
Clean the detergent dis-
penser drawer and attach the
conditioner insert securely.
Washing heavily
creased. Too mush washing probably
put in.
Pay attention to the maxi-
mum filling quantity (see
Program Tables). For easy-
care textiles, select the pro-
gram EASY IRON.
The washing has not
been spun as dry as
usual. The washing was not able to
be distributed evenly in the
drum prior to spinning. Always load the drum as ful
as possible with a combina-
tion of large and small items.
Washing not well spun.
Residual water still vis-
ible in the drum.
Fault code
E20
ap-
pears. The indicator
RINSE flashes.
Drainage hose bent. Remove the bend.
Maximum pump head (outlet
head 1m from unit's floor
surface) exceeded.
Consult Customer Service.
They can supply a retrofit kit
as a special accessory for de-
livery heads of more than
1m.
Solution pump blocked.
Switch off the unit and pull
out the mains plug. Clean
the solution pump.
If a siphon is connected: Si-
phon blocked.
Clean the siphon.
Problem Possible Cause Remedy