Dake Dura Press Force - 10/25 - Manual

Force 10DA & Force 25DA 1
INSTRUCTIONS AND PARTS
LIST FOR MODEL
FORCE 10DA and FORCE 25DA
(Double Acting, Electrically-Operated Hydraulic Press)
Thank you for buying Dake !!!!
We hope you enjoy many years of using your new Dake hydraulic press. We hope you find these instructions
helpful, if you have any questions please give us a call, or just stop by for a factory tour.
724 Robbins Road
Grand Haven, MI 49417
Phone: 616-842-7110 800-937-3253
Ordering information
Please order all parts by part number and name; also mention model number as shown
on plate attached to the frame of the press.
Note: This press is not intended for stripping operations! Personal injury or
machine damage can result.
Press set-up
Installation Instructions
Your new Dake Press has been packaged in a manner to prevent damage to any critical components; some
assembly may be required. All parts in the accessory box are critical to the function of your press. Some
presses may come completely assembled.
NOTE: FOR EASE OF ASSEMBLY LEAVE THE PRESS FRAME MOUNTED ON THE SHIPPING
SKID
1. Remove plastic from the machine.
2. Open the box and you will see a pumping unit, with the press still
laying on its side. Locate the four holes on the side of the press facing
up.
3. Place the pumping unit on the side of the press with the mounting
bracket facing down, making sure the holes all line up.
4. There are four bolts, washers and nuts in a bag, in the box. Put the
bolts in the holes using the washers and nuts. Make sure all nuts and
bolts are tight.
5. With the press lying on its side fill the reservoir with DTE 24 Mobile oil
or equivalent with 2 gallons of oil.