Kenwood TH-K20A - Manual (Page 31)

23
CALL CHANNEL
The Call Channel can be recalled instantly, no matter the frequency on which you
are operating the transceiver. For instance, you may use the Call Channel as an
emergency channel within your group. In this case, Call Scan will be useful.
The default Call Channel frequency is 144.000 MHz (TH-K20A/E)/ 430.000 MHz
(TH-K40A/E).
Note: Unlike memory channels 0 to 199, the Call Channel cannot be cleared.
RECALLING THE CALL CHANNEL
Press [CALL] to recall the Call Channel.
• The Call Channel frequency and “C” appear.
• To return to the previous frequency, press [CALL] again.
REPROGRAMMING THE CALL CHANNEL
1 Select your desired frequency and related data (Tone, CTCSS, DCS, or offset
direction, etc.).
• When you program the Call Channel as an odd-split channel, select a receiving
frequency first.
2 Press [F] - [CALL].
• The selected frequency and related data are stored in the Call Channel.
To also store a separate transmit frequency, continue with the following steps.
3 Select the desired transmit frequency.
4 Press [F], then press [PTT] + [CALL].
• The separate transmit frequency is stored in the Call Channel.
Note:
◆
When you recall an odd-split Call Channel, “ ” and “ ” appear on the display.
◆ Transmit offset status and Reverse status are not stored in an odd-split Call Channel.