Kenwood DPX504U - Manual (Page 33)

English |
33
Dial a Number
1
Enter Bluetooth mode
Press the [LOG] button for at least 1 second.
2
Select the number dial mode
Turn the [VOL] knob and press it when the
desired item is displayed.
Select “Number Dial”.
3
Enter a phone number
Operation type Operation
Select the numbers. Turn the [VOL] knob.
Move to the next digit. Press the [
¢] button.
Delete the last digit. Press the [
4] button.
• Press the number ([1] – [0]), #([FM]), *([AM]), or
+([ ¢]) button on the remote controller.
✍ To erase the entered phone number digit
by digit:
Press the [
4] button on the remote
controller.
4
Make a call
• Press the [VOL] knob.
• Press the [DIRECT] button on the remote
controller.
⁄
• You can input max 32 digits.
Make a Voice Dialing Call
1
Enter voice recognition mode
Press the [ATT] button for at least 1 second.
2
“PB Name?” is displayed.
When a beep is heard, say the name within 2
seconds.
3
“PN Type?” is displayed.
When a beep is heard, say the category name
within 2 seconds.
4
Make a call
Press the [VOL] knob.
✍ This step is the same as step 4 of the procedure
in
<Calling a Number in the Phone Book> (page
32) . You can make a call or select a category.
⁄
• If your voice cannot be recognized, a message is displayed.
Pressing the [VOL] knob allows you to retry voice input.
Refer to
<Troubleshooting Guide> (page 76) .
• Both the name and category require registration of a voice
tag. Refer to
<Setting a Voice Command for Category>
(page 68) .
• Audio sound is not output during voice recognition.