Videotec ULISSE PLUS NETCAM - Manual (Page 17)

Instruc
tions manual - English - EN
15
7.1.2 Assembling the camera and
motorised lenses
The correct device working, in the stated
temperature range, is guaranteed with the
use of camera and lens with temperature
from -10°C up to +60°C.
The customer has to take care of assembling the
camera and lenses.
7.1.2.1 How to open the housing
To open the housing, undo the screws on the sides
and lift the upper body.
Fig. 9
On removing the upper section of the
housing, accompany it until the anchoring
cable is taut. Do not drop the upper section
of the housing as this could cause the cable
to snap.
7.1.2.2 How to install the camera
Take out the inner support slide (01) loosening the
fastening screws (02). Attach the camera using the
1/4" screw and adjust the internal slide so that the
lens and camera are positioned correctly.
Fasten down the adjustable slide in the correct
position using the appropriate screws. When
positioning the camera use also the spacers supplied
for this purpose (03).
03
02
01
Fig. 10
Reposition the inner slide and tighten the screws that
had been loosened previously.